A DYI Project: Kitchen Cabinet Staining

Whether you’re buying new cabinets or refurbishing old ones, a fresh stain on the wood in your kitchen can make your cabinet design stand out as if it were new again.

If you’re the type that likes to do small DYI projects, staining kitchen cabinets won’t be a tough thing. The key steps to creating the method go smoothly are to organize well beforehand, to figure in a neighborhood where you have got enough room, and to always be very careful with the stain.

As the name suggests, wood stain isn’t easy to get rid of should it go somewhere you didn’t want it to.

While we will only hope your project cracks with no mishaps, we will talk you thru the process; starting with the materials and preparation you ought to do beforehand, on to a way to stain your cabinets, and ending with a way to put everything back in situ afterward.

Gathering your materials

If you’re planning on staining new, unfinished cabinets, you almost certainly won’t need to sand them. However, if you’re restoring your older, already-installed cabinet design, you will need to sand away the old finish and stain first.

If you are doing must sand, get two differing kinds of paper: perhaps 110 grit and 220 grit. You’ll also need a drill or screwdriver to require apart your cabinets, and a few small plastic bags to carry the hardware. Get some rags and basic cleaning supplies too, additionally as some notepaper.

A tarp are useful for covering the ground and providing you with a neighborhood to figure on. An open space sort of a garage is a perfect spot, and dealing during a well-ventilated area is extremely recommended.

You’ll also need the stain you will be using, additionally as polyurethane to complete the work. Pick colors which will accent or enhance your cabinet design, and use oil-based polyurethane with oil-based wood stain. a touch little bit of both of those will go an extended way.

Staining your cabinets

Start by removing all the hardware from your cabinets, including the hinges. Lay out the pieces on the tarp, and put the hardware within the bags. Label everything with the notepaper so you remember a way to put it all back.

If you wish to sand, lightly sand every bit with the heavier, 110-grit sandpaper first. Then use the finer 220-grit sandpaper. you do not must spend much time on this step, but your cabinet design will thanks if you’re thorough.

For the next step, work the stain into the cabinet pieces with the rags. Follow the grain of the wood, and do not apply it too thick. Let it dry and provides it a look: does it must be darker? If so, you’ll be able to apply more coats until you have got the right shade.

Once you have got the correct color and therefore the wood is dry, apply two coats of polyurethane.

Replacing your cabinets

Once your cabinets are stained to the correct color and therefore the polyurethane has completely dried, you’re able to put it all back together. Keep in mind that you want the finish to dry completely, so don’t touch it until that is done. If you handle the cupboards too early you’ll be able to leave smudges or fingerprints, marring your cabinet design.

Replace the cupboards and every one the hardware. try and only touch the wood pieces on their edges when possible, to avoid getting the new faces dirty.

Remember too that wood stain will be difficult to wash off your hands. Pro tip: if wood stain does get on your hands, try rubbing them with oil before using soap.

In just one day, you’ll be able to transform your cabinet design into something greenhorn, whether or not the cupboards themselves are old.

Begin by gathering your materials and finding an honest space to figure in. Remove all the hardware and lay out the cupboard pieces, and apply coats of stain until you get the correct look. Finally, complete the job with a polyurethane coating, and put it back together.

Virgil Jordan

Back to top